Hot Melt Adhesive (black strip) 
 Black hot melt adhesive of high viscosity force for the bonding of the PC board, hard PVC plastic, acrylic, ABS plastic, ceramics, electronics industry, small metal and so on. 

 Hot melt adhesive (special transparent adhesive tape) 
 For advanced toys, leather products, ceramics, arts and crafts, hair accessories. 

 Hot melt adhesive particles (transparent yellow tablets) 
 For bonding and sealing of vehicle interiors, gasoline, diesel, oil and other motor vehicle air filter. 

 Hot melt adhesive tablets (low rubber) 
 Rapid automation for all types of carton, box packaging. 

 Hot melt adhesive tablets (yellow tablets opaque) 
 Force of high viscosity, low viscosity, fast-drying, especially for wood products, Speaker products. 

 Hot melt adhesive particles (transparent white tablets) 
 Suitable for arts and crafts, hair accessories, Christmas products, long-haired toys, cloth toys, fixed electronic components, PC boards. 

 Hot melt adhesive tablets (yellow grain) 
 Applies to the packaging and printing of the book case, carton class production, paper laminated products, luggage adhesive, wood Edge, artwork, packaging, toys, arts and crafts. 

 How to use hot melt glue gun 
 (I) hot melt glue gun before use, please check if the power supply power, the bracket is ready; used glue gun to push the plastic is smooth. 
 (2) the use of hot melt glue gun, please warm up for five minutes or so, the glue gun when not in use, upright on the desktop. 
 (3) Please keep the surface clean hot melt adhesive strips to prevent impurities plug the muzzle. 
 (4) glue gun in the course does not a glue, check the glue gun to have a fever. Glue gun can not be normal and fever, may be due to: a glue gun power supply is not energized; 2 glue gun fever has burnt out; glue gun to heat may be due to: a muzzle admixture, to professionals to deal with; 2 glue gun down the plastic leaving the strip thicker, simply strip gently side to side rotation after pulled out a small portion of the thicker part of the cut strips, and then continue to use. (5) glue gun tape did not run out, please try not to strip from the glue gun to pull out, or they might pour rubber, impact plastic speed. 
 (5) in the strip of glue gun reflux, should immediately disconnect the power to stop using, be professionals repairs before use. 
 (6) If the glue gun in a continuous heating over 15 minutes not in use, disconnect the power supply, can improve the life of the glue gun. 
 (7) If unknown, please contact the factory, thank you